Last week in our woodworking community, discussions were as varied as they were engaging. Members delved into the intricacies of tool handling and shared tips for improving craftsmanship. A debate arose around the efficacy of certain tool designs, while others focused on the nuances of working with specific wood types. The community also exchanged advice on setting up tools for ergonomic woodworking, highlighting both the challenges and solutions.
This Week’s Hot Topics
My anti-roll handle rolled anyway
A lively discussion emerged around the unexpected rolling of an anti-roll handle. Members shared experiences and possible design improvements to tackle this quirky issue. Read more
Low-angle block plane for sapele
Woodworkers debated the best techniques and tools for working with sapele, specifically whether a low-angle block plane is ideal. This conversation is packed with practical advice for anyone handling this unique wood. Read more
Spokeshave setup for comfy chair arms
The community explored the art of setting up a spokeshave to create comfortable chair arms, sharing tips to ensure smooth edges and ergonomic designs. Read more
Looking forward to another week of shared learning and woodworking passion. See you on the forum!
On the ‘anti-roll handle’ question from last week, I slip 1 in. heat‑shrink over round handles (marking knife, burnisher), warm it, then press one side flat on a scrap until it cools — cheap, adds grip, and it stops the wander on a tilted bench. If you don’t love the look, a single #18 O‑ring near the ferrule is a reversible compromise.
I run a thin bead of hot glue down one side of round handles, then smooth it with the nozzle — it makes a low, grippy flat that “stops the roll” without chewing up the finish. If the handle’s really glossy, I scuff a narrow strip with 320 first; on raw/oiled ones I use a tiny leather dot with hide glue instead. Peels off clean later if you change your mind, @Jamie.